Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Rialto, CA
Gate installation in Rialto usually means replacing a heavy welded-steel or wrought-iron gate that has outlived its hinges, posts, or track – or adding an automatic opener to one that was never built for it. Most of the driveways we see here run along the side of a 1950s-to-1980s stucco tract home, where the gate hangs from aging wood-and-stucco posts or sun-cracked concrete footings. The hot, dry summers and the gusty pass winds off the Cajon Pass beat these gates up faster than homeowners expect. Call (844) 405-5765 for a free estimate, and we’ll send a gate specialist to look at what you have.
Why Rialto Homes Are Different
Rialto is a working-class Inland Empire suburb where most driveways and side yards are gated by welded steel and wrought-iron swing or sliding gates. A lot of them were owner-installed or hand-me-downs from a neighbor or relative, so gate repair here is less about ornamental aluminum and more about rusted hinges, sagging swing posts, and salvaging heavy custom ironwork the homeowner can’t afford to replace. The city’s wind-corridor location at the base of the Cajon Pass means gates get beat up by gusty Santa Ana and pass winds in a way flat-land neighbors don’t see. That wind is a real factor: it rattles loose hinges on exposed corner-lot fences first, then starts bending sliding-gate tracks.
The housing stock shapes the work, too. Rialto is dominated by single-story stucco tract homes on wide lots with long side-yard driveways off the alley or street, plus a growing share of newer infill in the 92377 north end. The older stock means many gates hang from aging wood-and-stucco posts that have rotted inside the wall cavity, or from concrete footings sun-cracked by decades of Inland Empire heat. On the older south-side blocks around 92376, it’s common to find gates anchored into the same stucco-and-lath walls as the house. A sagging gate there often means patching cracked stucco around the post, not just swapping a hinge. The climate also does its part: hot, dry summers dry out and warp wood gates and speed rust on steel, while winter rain and the occasional Santa Ana gust season loosen hinges and bend sliding-gate tracks. None of this is what a flat, mild, coastal city deals with, and a gate company that treats Rialto like everywhere else will misdiagnose the problem.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Main Rialto Services
Rialto homeowners call us most about two things: a gate that has stopped swinging or sliding properly, and an electric opener that has stopped responding. Both are covered below, each with its own dedicated Rialto page.
Gate Repair in Rialto
A swing gate that drags on the ground, a sliding gate that jumps its track, a weld that has cracked through – these are the calls we get from Rialto’s older neighborhoods most weeks. The pass winds accelerate everything: a hinge that would last years in a calmer city works loose here, and a gate with any play in it gets slammed harder every season. We work on the gate you already have, from the motor to the hinge, and we don’t push a replacement when a repair is what the gate needs. Gate Repair in Rialto covers manual and mechanical work in more detail.
Electric Gate Repair in Rialto
When an automatic gate stops opening or closes halfway and reverses, the problem is usually in the operator, the control board, a safety sensor, or the wiring between them. Rialto’s heat and wind make this worse: sun-baked conduit and vibrating connections both fail earlier than they should. Electric gate diagnosis starts with understanding the system, not swapping parts, and we service the brand you already have – LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. Electric Gate Repair in Rialto has the full breakdown.
Gate Installation in Rialto
Gate installation in Rialto usually means one of two jobs: replacing a gate that has rusted or sagged past the point of repair, or converting a manual gate to automatic operation. On the older south-side blocks, the real work is often the posts and footings – a new gate hung on a rotted stucco post will sag again within a season. On newer infill lots in 92377, it’s more often a clean install with new steel posts set to proper footing depth. Either way, we handle the full job through Gate Installation, from demolition of the old gate to the final weld and paint.
Automatic Gate Installation
Signs you need it
You’re tired of getting out of the car to open the gate, or you want controlled access to the driveway without replacing the gate itself.
What it costs in Rialto
Automatic gate installation in Rialto typically runs $2,500 to $7,500 depending on the operator brand, gate weight, and whether new conduit must be run from the house.
How we do it
We mount the operator, set the safety edges and photo eyes, run the power and control wiring, and program the remotes and keypad before testing the full cycle.
Driveway Gate Installation
Signs you need it
The existing gate is rusted through at the hinges, the post is leaning, or the gate no longer closes square against the latch.
What it costs in Rialto
A new driveway gate in Rialto typically runs $1,500 to $5,000 for a welded steel gate, with the final price set by width, height, and whether we replace the posts too.
How we do it
We measure the opening, cut and weld the frame, hang the gate on new hinges, and set or re-anchor the posts so the gate closes true.
What Gate Installation Costs in Rialto
| Item | Typical range in Rialto |
|---|---|
| Welded steel driveway gate | $1,500 – $5,000 |
| Automatic gate opener and install | $2,500 – $7,500 |
| Full install with new posts and footings | $3,000 – $9,000 |
How long does gate installation take in Rialto?
Most driveway gate installations take one to two days on site. Automatic openers add wiring and programming time, and jobs that need new concrete footings cure before the gate is hung.
Do you handle the power run and the safety edges?
Yes – we run the conduit and wiring from the panel to the operator, set the safety edges and photo eyes, and test the full cycle. Call (844) 405-5765 for a written estimate. The price is agreed before any work starts.
Brands We Service in Rialto
We work on the brand you already have. Our technicians are factory-familiar with BFT, Linear, Viking, and Ghost Controls, among others, and we carry common boards, remotes, and safety parts in local stock so a Rialto repair doesn’t wait on a shipment. Take a look at our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Rialto, CA
| Service | Typical range in Rialto |
|---|---|
| Gate repair – hinge, latch, or weld fix | $150 – $450 |
| Swing or sliding gate realignment | $200 – $500 |
| Electric gate diagnosis | $150 – $350 |
| Operator replacement | $700 – $1,800 |
| Control board replacement | $400 – $1,200 |
| Safety sensor or loop repair | $250 – $600 |
| Wire repair or conduit replacement | $200 – $700 |
| Welded steel driveway gate | $1,500 – $5,000 |
| Automatic gate opener and install | $2,500 – $7,500 |
| Full install with new posts and footings | $3,000 – $9,000 |
| Gate maintenance visit | $150 – $400 |
In Rialto, price gets pushed up most by rotted stucco posts that need rebuilding, heavy custom ironwork that has to be cut out rather than adjusted, and long power runs from the house to a driveway gate at the back of the lot. Whatever the job, the estimate is free and the written estimate sets the final price before any work begins.
Neighborhoods We Serve in Rialto
We cover the whole city, from the older south-side blocks around 92376 to the newer infill in north Rialto’s 92377. Our fast dispatch from 7am to 7pm, Sunday through Friday, gets a technician out the same day in most cases for repair calls.
- North Rialto
- South Rialto
- Las Colinas
- Renaissance
- West Rialto
Service Area – Cities Near Rialto
Our gate specialists cover Rialto and the surrounding Inland Empire cities. If you’re in Muscoy, CA, Bloomington, CA, Fontana, CA, or San Bernardino, CA, we can schedule a visit the same way we do for Rialto homeowners.
Serving Rialto, CA – Our Local Coverage Area
We serve Rialto and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Gate Company in Rialto
For most repairs, same-day service is available. We answer 24/7 and dispatch technicians from 7am to 7pm, Sunday through Friday, with fast response across Rialto’s neighborhoods.
Most cities require a permit when posts or footings are set, and Rialto is no different. We can tell you what’s typically needed for your job, but your city’s building department has the final word.
Often yes. We can re-anchor posts, re-hang a sagging gate, add an automatic opener, or weld in new frame sections, and we only recommend replacement when the steel or the footing no longer holds.
Call (844) 405-5765 for a free estimate on any gate job in Rialto. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically within 60 minutes.
- 4You approve before work beginsNothing starts until you say go.
What Rialto Customers Say
"Gate stopped halfway and sat there for two days blocking the driveway. He found a dead capacitor in the operator, had one with him, and we were moving cars again in under an hour."
- Claudia Hernandez"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
- Colleen Padgett"We had a hydraulic arm leaking fluid onto the driveway. Replaced, cleaned up the stain as best he could, and it's been dry for months."
- Nicole Rhodes